Today I finished sanding down the excess parts of corner blocks on the bottom side of the lower wings. I then glued the filler sticks in place. After that I went over to the airport and burned some holes in the sky in my buddies S-1S. Several hours later I came back and decided that I wanted finish the taper on the lower wing rear spar at the tip so i could glue the last two ribs. On all the other spars I used my circular saw to make these cuts but it was done before the hinges and doublers were installed. This time I used my sliding compound miter saw and it worked really well.
Time spent 4 hours
Total time spent 366 hours